高 浓 度 含酚 含 醛 废水 预 处理 工 艺研 究
吴慧英
1
周万龙
1
黄
晟
2
陈积义
1
李欣棋
1
朱建强
1
( 1 湖南大学土木工程学院水工程与 科学系, 长沙
410082;
2 湖南省环境科学研究院, 长沙
410007)
摘要
研究了缩合/ 精馏 活性炭吸附 Fenton 氧化工艺预处理高浓度含酚含醛废水的效果,
对影响除污效果的因素进行了试验探讨, 并确定了工艺优化条件。高浓度含酚醛废水经本工艺处理
后, COD
Cr
、苯酚、甲醛去 除率 分别为 98. 9% 、99. 7% 、99% , 出水 COD
Cr
约 1 350 mg/ L , 苯 酚低 于
70 mg/ L、
BOD
5
/ COD
Cr
约为 0. 33, 能满足最终生化处理要求。
关键词
高浓度含酚含醛废水
缩合/ 精馏 活性炭吸附 Fenton 氧化
Study on pretreatment of high- concentrated phenol and aldehyde wastewater
Wu Hu-i ying
1
, Zhou Wan- long
1
, Huang Sheng
2
, Chen J-i yi
1
, L i Xin-qi
1
, Zhu Jian- qiang
1
( 1 . D ep ar t ment of Water Engineer ing and Science, Col lege of Ci vil Engineer ing , H unan
Uni versity , Changsha 410082 , Chi na; 2 . H unan Province Environmental Science Inst it ut e,
Changsha 410007 , Chi na)
Abstract: Composite process composed of condensat ion/ rectification- act ivat ed carbon adsorption
and Fenton oxidation was researched experiment ally for pretreat ment of high- level phenol and aldehy de
w ast ew at er. T he inf luencing factors w ere investigated and t he opt im al w orking condit ion w as sought
for. By this w ay the strengt h of t he crude wastewater w ith hig h concent rat ed phenol and aldehyde w as
decreased evident ly, removals of 98. 9% , 99. 7% and 99% have been obtained for CO D
Cr
, phenol and
aldehyde respect ively. T he rem ained COD
C r
and phenol in t he out flow of this process are lower t han
1 350 mg/ L and 70 mg/ L respect ively and w ith BOD
5
/ COD
C r
ratio about 0. 33. It is believed that t his
w ill be quit e favorable for t he further biolog ical t reatment .
Keywords: H ig h- concent rat ed phenol and aldehyde w ast ew at er; Condensat ion/ rect if icat ion; A ct-i
vat ed carbon adsorpt ion; Fent on ox idat ion
苯酚与甲醛缩合生产酚醛树脂过程中产生的含
酚醛废水, 其含酚含醛浓度高达几万 mg/ L , 还含有
大量醇类、
酸类等有毒物, 处理难度大。国外一般采
用焚烧处理, 但费用太高; 国内含酚废水以生化处理
为主, 但高浓度含酚醛废水需采用萃取、化学氧化、
吸附、
缩合等预处理降低有毒有害物的毒性和浓度
后才可生化处理。而对含酚醛浓度过高的废水, 上
述预处理工艺的效果仍不理想。在加热及酸碱催化
下, 酚醛废水中的酚与甲醛可缩合生成酚醛树脂沉
淀而去除
[ 1]
。因探索性试验发现碱催化效果不佳,
本研究拟采用酸性缩合/ 精馏 活性炭吸附 化学
氧化工艺预处理酚醛废水。
1 试验材料与方法
试验废水取自某公司酚醛保温材料生产废水, 废
水水质为 COD
Cr
128 960 mg/ L 、
苯酚 21 491 mg/ L、甲
醛 18 958 mg / L 、pH 6~ 8。废水预处理工艺流程见
图 1。
缩合/ 精馏装置为一多口玻璃烧瓶, 上设精馏塔
及回流冷凝装置, 于恒温加热器中加热, 废水中的酚
和醛经酸催化生成酚醛树脂, 反应中可按需要投加
56
给水排水
Vol. 31
No. 12
2005