第25卷第24期
2009年12月
中国给水排水
CHINA
WATER&WASfrEWATER
V01.25 No.24
Dec.2009
印染废水深度处理工程及工艺改进
丛丛,
汪晓军
(华南理工大学环境科学与工程学院,广东广州510006)
摘要:
采用曝气生物滤池(BAF)/臭氧预氧化/BAF组合工艺对印染废水二级生化处理出
水进行深度处理,COD从进水的90~160 mg/L左右稳定降至30 mg/L以下,色度从进水的“一
128倍左右降至2~4倍,出水浊度<l NTU,排放水质达到回用要求,处理成本为1.43元/m’。之
后又对工艺进行改进。设计出一体化装置,COD去除率>70%,其他指标均达到排放标准,处理成
本仅为0.89元/m3。
关键词:
印染废水;
深度处理;
臭氧;
曝气生物滤池;
一体化工艺
中图分类号:X703
文献标识码:C
文章编号:1000—4602(2009)24—0058—04
Advanced
Treatment
Engineering of Printing and Dyeing
Wastewater
and Process
Improvement
CONG Cong.
WANG
Xiao-jun
(College of
Environmental Science and Engineering,South China University
of
Technology,
Guangzhou 5
10006,China)
Abstract:The combined process of biological
aerated
filter(BAF),ozonation
and BAF
was
used
for advanced treatment of printing and dyeing
wastewater
after secondary biochemical treatment.COD is
reduced from 90—160 ms/L in the influent
to
below 30 ms/L。color is decreased from 64—128 times in
the influent
to
2-4 times,and the
turbidity
is less
than
1 NTU.The
effiuem
call
meet the reused
water
quality for the production
process.The
treatment
cost
is
about
1.43 yuan/m3.After the improvement of
the
combined process,the integrated equipment
was
designed.The removal
rate
of COD is more than
70%,and
other indexes
can
meet the
discharge
requirements.The
treatment
cost
is only 0.89 yuan/m3.
Key words:printing and dyeing
wastewater;
advanced treatment;
ozone;
biological
aerated
filter;
integrated process
广东某大型针织品和纺织品生产企业主要以纺
织、洗水、印染等为主。该企业原有一套废水处理系
统,废水经过水解酸if_/接触氧似沉淀处理后,无法
满足回用要求,为此该企业委托华南理工大学设计
了BAF/臭氧预氧似BAF深度处理回用系统,并进
行了建造和调试。目前该深度处理系统已正常运
行,出水水质达到回用要求,并通过了验收。在运行
稳定后,为了降低运行成本,又进一步设计了一体化
装置。对BAF/臭氧预氧{比/BAF深度处理工艺和
改进后的一体化工艺进行总结,可为该类废水的深
度处理提供借鉴。
1废水水质、水量和排放标准
该公司的深度处理水量为5
m3/h,24
h连续进
水,进水温度<40℃。深度处理系统的进水为现有
印染工业废水处理厂二级生化出水,COD平均浓度
为90一160 ms/L,色度为64—128倍,pH值为7—
8。处理出水回用于生产,主要水质指标的限定值如
下:COD≤30
ms/L、BOD5≤20
mg/L、色度≤4倍、SS
・58・
万方数据